Kosten 3D Druck: Unterschied zwischen den Versionen
Keine Bearbeitungszusammenfassung |
|||
| Zeile 48: | Zeile 48: | ||
=== Störungsbehebung === | === Störungsbehebung === | ||
*[http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide Troubleshooting Guide von 3DVerkstan.se] | *[http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide Troubleshooting Guide von 3DVerkstan.se] | ||
*[http://umforum.ultimaker.com/index.php?/forum/28-troubleshooting/ Ultimaker Forum(!)] | |||
== Kossel Clear == | == Kossel Clear == | ||
... | ... | ||
Version vom 12. Oktober 2014, 23:19 Uhr
| Name | Typ | Nozzle | Heizbett | Status |
|---|---|---|---|---|
| Ulti #1 | Ultimaker Original | 0.4mm | OK | |
| Ulti #2 | Ultimaker Original | 0.6mm | OK | |
| Ulti #3 | Ultimaker Original | 0.6mm | X | OK |
| Ulti #4 | Ultimaker Original | 0.4mm | X | OK |
| Kossel | Kossel Clear | ? | ? | Noch nicht in Betrieb |
Ultimaker Original
Manuals
Assembly
Störungsbehebung
Kossel Clear
...