Kosten 3D Druck: Unterschied zwischen den Versionen
Keine Bearbeitungszusammenfassung |
|||
| Zeile 39: | Zeile 39: | ||
== Ultimaker Original == | == Ultimaker Original == | ||
Manuals | Manuals | ||
[https://www.ultimaker.com/spree/uploads/198/original/Ultimaker_Original_User_Manual.pdf Ultimaker User Manual] | *[https://www.ultimaker.com/spree/uploads/198/original/Ultimaker_Original_User_Manual.pdf Ultimaker User Manual] | ||
[http://luzern.fablab.ch/site/wp-content/uploads/2014/05/FabLab_Luzern_Anleitung_ULTIMAKER.pdf FabLab Luzern] | *[http://luzern.fablab.ch/site/wp-content/uploads/2014/05/FabLab_Luzern_Anleitung_ULTIMAKER.pdf FabLab Luzern] | ||
Assembly | Assembly | ||
[https://www.ultimaker.com/spree/uploads/197/original/Ultimaker_Original_Assembly_Manual.pdf Ultimaker Assembly Manual] | *[https://www.ultimaker.com/spree/uploads/197/original/Ultimaker_Original_Assembly_Manual.pdf Ultimaker Assembly Manual] | ||
=== Störungsbehebung === | === Störungsbehebung === | ||
[http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide Troubleshooting Guide von 3DVerkstan.se] | *[http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide Troubleshooting Guide von 3DVerkstan.se] | ||
Version vom 12. Oktober 2014, 23:17 Uhr
| Name | Typ | Nozzle | Heizbett | Status |
|---|---|---|---|---|
| Ulti #1 | Ultimaker Original | 0.4mm | OK | |
| Ulti #2 | Ultimaker Original | 0.6mm | OK | |
| Ulti #3 | Ultimaker Original | 0.6mm | X | OK |
| Ulti #4 | Ultimaker Original | 0.4mm | X | OK |
| Kossel | Kossel Clear | ? | ? | Noch nicht in Betrieb |
Ultimaker Original
Manuals
Assembly