Ultimaker Original: Unterschied zwischen den Versionen

Aktuelle Version vom 28. August 2020, 16:32 Uhr

@@ Zeile 1: / Zeile 1: @@
-== Manuals ==
-*
+=== Manuals ===
-== [https://www.ultimaker.com/spree/uploads/198/original/Ultimaker_Original_User_Manual.pdf Ultimaker User Manual] ==
+*[https://www.ultimaker.com/spree/uploads/198/original/Ultimaker_Original_User_Manual.pdf Ultimaker User Manual]
+*[http://luzern.fablab.ch/site/wp-content/uploads/2014/05/FabLab_Luzern_Anleitung_ULTIMAKER.pdf FabLab Luzern]
-*[http://luzern.fablab.ch/site/wp-content/uploads/2014/05/FabLab_Luzern_Anleitung_ULTIMAKER.pdf FabLab Luzern]
+=== Wiki ===
+[https://reprap.org/wiki/Ultimaker https://reprap.org/wiki/Ultimaker]
 === Störungsbehebung ===
 *[http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide Troubleshooting Guide von 3DVerkstan.se]
 *[http://umforum.ultimaker.com/index.php?/forum/28-troubleshooting/ Ultimaker Forum(!)]
 *[http://www.youtube.com/watch?v=7B1VZDrRuIg Kalibrierung (Video)]
+=== Bauanleitung ===
-=== Selber bauen ===
+*[https://www.ultimaker.com/spree/uploads/197/original/Ultimaker_Original_Assembly_Manual.pdf Ultimaker Assembly Manual]
+*[https://ultimaker.com/en/products/ultimaker-original Ultimaker Original Produktseite]
-*[https://www.ultimaker.com/spree/uploads/197/original/Ultimaker_Original_Assembly_Manual.pdf Ultimaker Assembly Manual]
+[[Category:Hardware]] [[Category:3D-Drucker]]
-*[https://ultimaker.com/en/products/ultimaker-original Ultimaker Original Produktseite]